Aktuelle Forschungsprojekte

Cryostats, Non-Metallic and Metallic

In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures

OVERALL SYSTEM OPTIMIZATION OF REFRIGERATION PLANT SYSTEMS FOR ENERGY TRANSITION AND CLIMATE PROTECTION

Tribological investigations of oil-refrigerant-material-systems

Practical training, diploma, master, bachelor

Testzentrum PLWP at ILK Dresden

Innovative Manufacturing Technologies for Cryosorption Systems

Non- invasive flow measurements

Intelligent innovative power supply for superconducting coils

Calibration of Low Temperature Sensors

Humidifier System for High-Purity Gases

Hydrogen and methane testing field at the ILK

Investigation of material-dependent parameters

Air-flow test rig for fan characteristic measurement

Development of test methods and test rigs for stationary integrated refrigeration units

Electrical components in refrigeration circuits

You are here: / Home

Low noise and non metallic liquid-helium cryostat

Industry and Research Institutes

Dr. rer. nat. Andreas Kade

+49-351-4081-5117

send mail

Low-noise Magnetic Field Cryostat for SQUID-Applications

Technical Data for the Cryostats

parameter	value
volume of liquid helium	5 to 12 litre (other volume possible)
time to complete evaporation of helium	3 to 7 days (depends on size)
heat load	0.1 W (in standby operation)
rate of helium evaporation	≤ 3 litre / day
holding time of the liquid helium	up to 4 days without refilling
initial noise of the cryostat	< 3 fT / Hz^½
helium leak test (He-vessel)	< 1 × 10^-11 mbar l / s

He-Cryostat, Height = 1000 mm, Diameter = 300 mm

ILK Dresden developed low noise magnetic field and non metallic helium cryostats made of GRP (glass reinforced plastics) with a high helium and vacuum holding time.

The cryostats can operate in a direction independent operation mode (tiltable arrangement) and hence they are suitable for a plurality of several applications.

The ILK concept offers much lower permeation rates inside the He-reservoir as comparable models from other manufacturers and is therefore perfect for SQUID (superconducting quantum interference device) applications and other long-term measurements.

The technical design of the cryostats is thus predestined for future sensor generation.

Specification

suitable for the cooling of SQUID-Sensors
non-metallic (GRP)
fast filling with LHe via thermosiphon
GRP exhaust gas cooled radiation shield for high efficiency.
small cold-warm distance feasible
low maintenance
other design variants possible on costumer request

Low noise magnetic field

The low-noise magnetic field of the cryostat was tested in the magnetically shielded room BMSR-1 of PTB Berlin and is smaller than the lowest resolution limit of the measurement system used, see figure below.