DEEN
Thermometer

Aktuelle Forschungsprojekte

Image OVERALL SYSTEM OPTIMIZATION OF REFRIGERATION PLANT SYSTEMS FOR ENERGY TRANSITION AND CLIMATE PROTECTION
Image Cryogenic liquid piston pumps for cold liquefied gases like LIN, LOX, LHe, LH2, LNG, LAr
Image Hybrid- Fluid for CO2-Sublimation Cycle
Image Ionocaloric cooling
Image Tribological investigations of oil-refrigerant-material-systems
Image IN-SITU SWELLING BEHAVIOUR OF POLYMER MATERIALS IN FLAMMABLE FLUIDS
Image Investigation of materials
Image Air-water heat pumps
Image Pulse-Tube-Refrigerator with sealed compressor
Image Innovative small helium liquefier
Image High Capacity Pulse Tube Cooler
Image Energy efficiency consulting - cogeneration systems
Image Cold meter
Image Test rigs for refrigeration and heat pump technology
Image Innovative Manufacturing Technologies for Cryosorption Systems
Image Thermal engines

You are here:   /  Home


Certifiable connection types in cryogenics

Dr. Andreas Kade

+49-351-4081-5117

Detachable and permanent connections, adhesive bond / form closure / force closure

The applications of cryogenic and vacuum technology impose special requirements on connection technologies. To determine the appropriate connections the application parameters such as temperature, vacuum and pressure, leak rate, materials, surface properties, radiation resistance, magnetic permeability etc. should be considered.

Connection technologies even if not being part of a standardized process more often have to be subject of a certification or qualification due to increasing quality requirements, e.g. pressure equipment directive 2014/68/EU. Therefore adequate designing and testing is necessary.

Alternative to electroplating process: cold gas sprayed copper layer (> 2 mm) with subsequent thread insertion
Alternative to electroplating process: cold gas sprayed copper layer (> 2 mm) with subsequent thread insertion

Innovations

The intended innovations relate to complete cryogenic systems considering the process chain from room temperature to low temperature range regarding the respectively required specifications. 

  • Development of application-related connection technologies with defined requirements and derived mechanical limit values 
  • Examination of existing connection technologies regarding applicability and further development towards secure and functional technologies
  • Evaluation and definition of application limits to aim for a feasible certification and the subsequent conformity with European guidelines

Project objectives

  • Application-related examination of various connection technologies
  • Further development and adaptation of existing connections to the requirements of cryogenic and vacuum technology
  • Examination on composite materials 
  • Examination on component geometries and their influence on the connection
  • Determination of process parameters (e.g. TIG welding, brazing,...) 
  • Determination of test limit values, especially for test specimens deviating from standards
  • Calculation according to common standards, simulation (FEM, ...) and testing
  • Realization and certification of selected connection technologies
Example of an examined connection between two materials (steel and PET) using a cutting edge at -90 ° C
Example of an examined connection between two materials (steel and PET) using a cutting edge at -90 ° C
show full article

Your Request

Data Privacy Settings

Cookies are used on our website. Some of them are mandatory, while others enable us to improve your user experience on our website.

Get more info about used cookies