Image Air-flow test rig for fan characteristic measurement
Image In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures
Image Intelligent innovative power supply for superconducting coils
Image Practical training, diploma, master, bachelor
Image Heat2Power
Image Low noise and non metallic liquid-helium cryostat
Image Test rigs for refrigeration and heat pump technology
Image Software for test rigs
Image Energy efficiency consulting - cogeneration systems
Image Low Temperature Tribology
Image Hydrogen and methane testing field at the ILK
Image Testzentrum PLWP at ILK Dresden
Image Reduction of primary noise sources of fans
Image Range of services laboratory analyses
Image Preformance measurements of heat exchangers
Image Investigation of coolants

You are here:   /  Home


Innovative Manufacturing Technologies for Cryosorption Systems

Euronorm, R&D

Sandra Tippmann

+49-351-4081-614

Vacuum Pumps for UHV and XHV

A cryosorption system is defined as a vacuum pump that captures gas on cryogenic surfaces (gas-binding vacuum pump). Thus pressures lower than 5-12 mbar are obtainable (realisation of UHV - ultrahigh vacuum and XHV - extremely high vacuum). Cryosorption systems rely on very good heat transfer performance. This is currently being achieved with a complex, cost-intensive and risky manufacturing process. Therefore the aim of this project is to develop a new manufacturing technology that does not have this disadvantage.

 

For this purpose, thermodynamically important variables, such as sorption heat and heat transfer resistance were determined mathematically. A test sample was developed and constructed based on these results.

After completion of the design the test sample will be produced.

In the further course of the R&D project a test stand will be set up on which the test sample can be measured. These measurements will be checked and validated in a CFD simulation. With the help of the CFD model, various simulations for future cryosorption systems can be carried out. For example cooling times for different activated carbon masses or the thermal performance under different conditions for the cooling medium can be determined using this method.

Finally the sample production (functional sample) of a cryosorption system made of stainless steel with a precisely defined heat transfer behaviour takes place. The functional model is measured in relation to the cooling performance and pressure loss of the cooling medium and the results obtained will be included into the creation of a process instruction for manufacturing future cryosorption systems.


Your Request

Further Projects

Image

Non- invasive flow measurements

PDPA - flow fields and particle sizes

Image

High temperature heat pump

Using waste heat from industrial processes

Image

Computational fluid dynamics CFD

Scientific analysis of flows


Contact

Institut für Luft- und Kältetechnik - Gemeinnützige Gesellschaft mbH
Bertolt-Brecht-Allee 20, 01309 Dresden


Secretary to the Management

+49-351-4081-520

+49-351-4081-525

Image ISO 9001
Bild Zuse Mitglied Bild SIG