Image Low Temperature Tribology
Image Helium extraction from natural gas
Image Solar Cooling
Image Micro fluidic expansion valve
Image State of system and failure analyses
Image Pulse-Tube-Refrigerator with sealed compressor
Image Thermostatic Expansion Valves
Image Testzentrum PLWP at ILK Dresden
Image Hydrogen and methane testing field at the ILK
Image Membrane-based Air Conditioning
Image Low noise and non metallic liquid-helium cryostat
Image Test procedures for electrical components
Image High Capacity Pulse Tube Cooler
Image Investigation of coolants
Image Low Temperature Measuring Service
Image Calibration of Low Temperature Sensors

You are here:  Home /  Consulting, Expert Opinions


BIM-based, auto-adaptive start-up tool for HVAC systems

BMWi Euronorm Innokom

09/2017-02/2020

Dipl.-Ing. Ronny Mai

+49-351-4081-684

in Bearbeitung

Maximisation of energy efficiency

Motivation

Recent times demand for improved technical requirements of buildings. Therefore, mechanical air-conditioning is almost not avoidable. Especially in large non-domestic buildings, the HVAC (humidification, ventilation, air-conditioning) can be very complex as is illustrated in Fig. 1 for a cooling system. Utmost care is necessary to start-up the systems, since a lot of interrelated parameters have to be defined. This set-up crucially determines the energy efficiency of the system. Unfavourable settings lead to a less efficient system. In practice, there occur often problems during start-up, e.g.,

  • proprietary modules for measurement, sensors, control prohibt free definition of energetically optimal algorithms (i.e., standardised solutions dominate the market, custom-made solutions are rare)
  • usually no full-load test possible, due to the weather conditions at start-up (design conditions cannot be reproduced)
  • time pressure -> low quality
  • usually just a start-up without appropriate adjustments; no energetic optimisation
  • missing start-up standards for HVAC systems

Contrary, data from the building information model (BIM) is available from the design process, but usually not employed later on. Although, these data allow the efficient utilisation of parameters which support the start-up engineer; provided applicable software is available. In addition, a large variety of sensors is distributed in modern buildings, which provide useful insight in the system behaviour. These sensors comprise temperature, pressure, flow rates, electrical and thermal powers, as well as switching states of throttles, flaps, switches, etc. These data can employed during the start-up process in order to adjust and optimise the system.


Your Request

Further Projects - Consulting, Expert Opinions

Image

Combined building and system simulation

Scientific analysis of thermodynamic processes in buildings and its systems

Image

Thermische Kälteerzeugung / Absorptionskältetechnik

Kraft-Wärme-Kälte-Kopplung, Fernwärme, Solarthermie oder Abwärme zur Kälteerzeugung

Image

Energy efficiency consulting - cogeneration systems

How efficient is my refrigeration system?

Image

Preformance measurements of heat exchangers

Is the heat exchanger properly sized?


Contact

Institut für Luft- und Kältetechnik - Gemeinnützige Gesellschaft mbH
Bertolt-Brecht-Allee 20, 01309 Dresden


Secretary to the Management

+49-351-4081-520

+49-351-4081-525

Image ISO 9001
Bild Zuse Mitglied Bild SIG