Aktuelle Forschungsprojekte

State of system and failure analyses

Modular storage system for solar cooling

Tribological investigations of oil-refrigerant-material-systems

High Capacity Pulse Tube Cooler

Cryogenic liquid piston pumps for cold liquefied gases like LIN, LOX, LHe, LH2, LNG, LAr

Electrical components in refrigeration circuits

OVERALL SYSTEM OPTIMIZATION OF REFRIGERATION PLANT SYSTEMS FOR ENERGY TRANSITION AND CLIMATE PROTECTION

Non- invasive flow measurements

Verification of storage suitability of cryo tubes

Test procedures for electrical components

Electrochemical decontamination of electrically conducting surfaces „EDeKo II“

Cryostats, Non-Metallic and Metallic

Swirl-free on the move...

Lifetime prediction of hermetic compressor systems

Test rigs for refrigeration and heat pump technology

Innovative Parahydrogen Generator Based on Magnets

You are here: Home / Measurements and Tests

Low Temperature Measuring Service

Industry and R&D

Dr. rer. nat. Matthias Schneider

+49-351-4081-5126

send mail

Measurement of Thermal Properties at Low Temperatures

The cool down to cryogenic temperature causes thermal stress within the structure of components or complete devices. Furthermore thermal material properties could change crucial.

Samples can be proved down to 10 K via temperature cycling tests and/or measurements of the thermal conductivity, the coefficient of thermal expansion (also as integral for large sample dimensions) and the heat capacity. An experimental station with optimised conditions for measuring the thermal conductivity of different materials is under construction.

Thermal Tests (Cycling)

Indicator	Minimal	Maximal
Cool down rate	25 K/h	200 K/min
Cool down cycles	1	Customer preference
Measuring accuracy	1 %	5 %
Temperature range	80 K (5 K)	450 K
Sample preparation	Customer material
Sample dimension	up to	Ø 400 mm x 550 mm
	other	dimenions on request

Thermal Conductivity

Indicator	Minimal	Maximal
Measuring range	10^-2 W/(m K)	10³ W/(m K)
Measuring accuracy	1 %	5 %
Temperature range	10 K	350 K
Sample preparation	Customer material
Sample dimension	up to	Ø 60 mm x 20 mm
	other	dimenions on request

Heat Capacity

Indicator	Minimal	Maximal
Measuring range	10J/(kg K)	10 J/(kg K)
Measuring accuracy	1 %	5 %
Temperature range	10 K	350 K
Sample preparation	Customer material
Sample dimension	up to	150 x 150 x 150 mm³
	other	dimenions on request

Coefficient of Thermal Expansion

Indicator	Minimal	Maximal
Measuring range	10^-6 K^-1	10^-4K^-1
Measuring accuracy	0.1 %	5 %
Temperature range	10 K	350 K
Sample preparation	Customer material
Sample dimension	up to	200 x 200 x 200 mm³
	other	dimenions on request