Image Software modules
Image In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures
Image Measurements on ceiling mounted cooling systems
Image Humidifier System for High-Purity Gases
Image Low Temperature Tribology
Image Innovative cryogenic cooling system for the recondensation / liquefaction of technical gases up to 77 K
Image Range of services laboratory analyses
Image Laseroptical measurement
Image Air-flow test rig for fan characteristic measurement
Image Reducing the filling quantity
Image Calibration of Low Temperature Sensors
Image Helium extraction from natural gas
Image Non- invasive flow measurements
Image Performance tests of refrigerant compressors
Image Electrical components in refrigeration circuits
Image Lifetime prediction of hermetic compressor systems

You are here:  Home /  Research and Development


Helium extraction from natural gas

EuroNorm GmbH, Federal Ministry for Economic Affairs and Energy

Dr. Erik Neuber

+49-351-4081-776

Innovative solutions for helium extraction

Separation of high purity helium from natural gas with very low helium concentrations

Helium is a very valuable noble gas with numerous applications in different fields of industry and research. Liquid helium is for example indispensable as a refrigerant in cryogenic systems such as magnetic resonance imaging. On Earth, the most important natural helium occurrences are found in the atmosphere and in natural gas. Because of its low concentration in air – only approx. 0.0005% – helium is recovered primarily from natural gas. However, in recent years an extreme worldwide helium shortage emerged, which has manifested itself in acute supply shortages and in large price increases. Therefore, new approaches and innovative processes for helium recovery from natural gas were examined within this research project at the ILK Dresden. In particular, these methods will be applicable to extract efficiently high purity helium from natural gas sources even with very low helium concentrations.

The main aim of the R&D project was to analyze different processes that can be used in the future as a possible technology of helium extraction plants. Such a plant could be used in the natural gas industry, either in close proximity to a natural gas source or away from the source connected to a gas pipeline.

Within this project a technological process of He extraction from natural gas divided into the following steps has been developed:

  • Development and research of the vortex tubes;
  • Analysis of the membrane separation technology for the helium recovery process;
  • Investigation of the condensation and adsorption stage;
  • Entire process modeling.

A simplified scheme in Figure 1 shows the process combination. The starting point is raw natural gas with a He content of less than 0.5 vol. %. The main component of the raw natural gas is methane, other components are nitrogen, higher hydrocarbons and small amounts of hydrogen and various noble gases.

Since natural gas can contain CO2 and ice which must be avoided in the subsequent low-temperature membrane process, thus, the first process step consists of the separation of CO2 by the combination of specially developed vortex tubes used in the condensation process.

The next step in the helium enrichment process is carried out by a membrane process that consists of five membrane stages. During this process, mainly methane and nitrogen are separated from the helium and so the helium is enriched to a purity from 0.5 vol. % up to about 97 vol. %. Low-temperature membrane separation was also studied within this project.

The last step in the process is the condensation and adsorption of the remaining CO2, N2 and CxHx traces from helium flow. The subsequent final step consists of the freezing out of low boiling impurities such as water and CO2, and adsorption of residual impure components for obtaining high purity helium with a purity of more than 99.999 %.

Thus, the technological processes in the field of membrane technology, low-temperature membrane gas separation, vortex tube, and condensation/adsorption have been investigated both theoretically and experimentally in this R&D project.


Your Request

Further Projects - Research and Development

Image

Micro heat exchangers in refrigeration

3D-printing of micro heat exchangers

Image

Electrochemical decontamination of electrically conducting surfaces „EDeKo II“

Improvement of sanitary prevention by electrochemical decontamination

Image

Electrical components in refrigeration circuits

High voltage tests under real conditions

Image

Influenced melting point of water by magnetic field

Controlled sub-cooling of products in freezing processes

Image

Non- invasive flow measurements

PDPA - flow fields and particle sizes


Contact

Institut für Luft- und Kältetechnik - Gemeinnützige Gesellschaft mbH
Bertolt-Brecht-Allee 20, 01309 Dresden


Secretary to the Management

+49-351-4081-520

+49-351-4081-525

Image ISO 9001
Bild Zuse Mitglied Bild SIG