Aktuelle Forschungsprojekte

Image Performance tests of condensing units
Image Investigation of coolants
Image Innovative Manufacturing Technologies for Cryosorption Systems
Image Micro heat exchangers in refrigeration
Image 3D - Air flow sensor
Image Refrigerants, lubricants and mixtures
Image Calibration of Low Temperature Sensors
Image Modular storage system for solar cooling
Image Characterisation of Superconductors in Hydrogen Atmosphere
Image Cryogenic liquid piston pumps for cold liquefied gases like LIN, LOX, LHe, LH2, LNG, LAr
Image Electrochemical decontamination of electrically conducting surfaces „EDeKo II“
Image Reduction of primary noise sources of fans
Image Verification of storage suitability of cryo tubes
Image Brine (water)-water heat pump
Image Industry 4.0 membrane heat and mass exchanger (i-MWÜ4.0)
Image Ice Slurry Generation

You are here:  Home /  Research and Development


High temperature heat pump

R. Noack

+49-351-4081-5219

Using waste heat from industrial processes

Industrial processes often generate waste heat, which can no longer be used in a technically sensible way due to its temperature level. Here, heat pump technology offers the possibility to increase the temperature level of the waste heat efficiently and without the use of fossil fuels and to make this heat energy usable again for processes.

Heat pumps for the heating of residential buildings are becoming increasingly widespread and will perspectively replace the oil and gas-operated heaters in most residential buildings.

For industrial applications with temperatures above 70°C the use of heat pumps in the market is still manageable or almost non-existent.

Within a research project the ILK has developed a demonstration object of a high temperature heat pump in the power range of 15 kW. Useful temperatures of 140°C were reached. The ILK is looking for partners who have application possibilities for the use of this technology.

From several funded research projects the ILK Dresden has collected manifold and extensive knowledge on this topic.

  • "Environmentally friendly CO2 heat pump for heating drinking water for industry" (FKZ MF090012)
  • "High temperature heat pump for applications above 120°C" (FKZ MF130081)
  • "High temperature heat pump module for commercial dryers" (FKZ ZF4079112RE7)
  • "Compact High-temperature Heat Pump with natural refrigerant" (FKZ KK5007302ZG0)

From these and other projects, the ILK Dresden has extensive experience with high temperature heat pumps with the following characteristics:

  • Refrigerants: partially fluorinated A1 safety refrigerants, natural refrigerants such as CO2 (R744), to a limited extent also combustible refrigerants such as propane (R290)
  • Heat source: air, water or thermal oil with temperatures 30°C - 100°C
  • Heat sink: air, water, steam or thermal oil with temperatures 80°C - 120°C+.
  • Power: 1 kW - 500 kW

Based on this knowledge we can develop and build high temperature heat pumps for you or support you in the development of such a heat pump.


Your Request

Further Projects - Research and Development

Image

Brine (water)-water heat pump

Test according DIN EN 14511 and 14825

Image

Air-water heat pumps

Test according DIN EN 14511 and 14825

Image

Micro heat exchangers in refrigeration

3D-printing of micro heat exchangers

Image

Electrochemical decontamination of electrically conducting surfaces „EDeKo II“

Improvement of sanitary prevention by electrochemical decontamination