Aktuelle Forschungsprojekte

Image Preformance measurements of heat exchangers
Image Testing of mobile leak detectors according to DIN EN 14624
Image High Capacity Pulse Tube Cooler
Image Hydrogen and methane testing field at the ILK
Image 3D - Air flow sensor
Image Micro fluidic expansion valve
Image Calibration leak for the water bath leak test
Image Development of test methods and test rigs for stationary integrated refrigeration units
Image Innovative Manufacturing Technologies for Cryosorption Systems
Image Swirl-free on the move...
Image Panel with indirect evaporative cooling via membrane
Image All-in-one device for freeze-drying and production of biomaterial
Image Pulse-Tube-Refrigerator with sealed compressor
Image Development of a Cryogenic Magnetic Air Separation Unit
Image Low Temperature Tribology
Image Multifunctional electronic modules for cryogenic applications

You are here:  Home /  Research and Development


Innovative Manufacturing Technologies for Cryosorption Systems

Euronorm, R&D

Sandra Tippmann

+49-351-4081-5131

Vacuum Pumps for UHV and XHV

A cryosorption system is defined as a vacuum pump that captures gas on cryogenic surfaces (gas-binding vacuum pump). Thus pressures lower than 5-12 mbar are obtainable (realisation of UHV - ultrahigh vacuum and XHV - extremely high vacuum). Cryosorption systems rely on very good heat transfer performance. This is currently being achieved with a complex, cost-intensive and risky manufacturing process. Therefore the aim of this project is to develop a new manufacturing technology that does not have this disadvantage.

 

For this purpose, thermodynamically important variables, such as sorption heat and heat transfer resistance were determined mathematically. A test sample was developed and constructed based on these results.

After completion of the design the test sample will be produced.

In the further course of the R&D project a test stand will be set up on which the test sample can be measured. These measurements will be checked and validated in a CFD simulation. With the help of the CFD model, various simulations for future cryosorption systems can be carried out. For example cooling times for different activated carbon masses or the thermal performance under different conditions for the cooling medium can be determined using this method.

Finally the sample production (functional sample) of a cryosorption system made of stainless steel with a precisely defined heat transfer behaviour takes place. The functional model is measured in relation to the cooling performance and pressure loss of the cooling medium and the results obtained will be included into the creation of a process instruction for manufacturing future cryosorption systems.


Your Request

Further Projects - Research and Development