Aktuelle Forschungsprojekte

Hydrogen and methane testing field at the ILK

State of system and failure analyses

Investigation of materials

Service offer for Leak Detection and Tightness Test

In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures

Heat2Power

Verification of storage suitability of cryo tubes

Panel with indirect evaporative cooling via membrane

Characterisation of Superconductors in Hydrogen Atmosphere

Brine (water)-water heat pump

Reducing the filling quantity

Innovative cryogenic cooling system for the recondensation / liquefaction of technical gases up to 77 K

All-in-one device for freeze-drying and production of biomaterial

Cryostats, Non-Metallic and Metallic

Behavior of multiphase cryogenic fluids

Energy efficiency consulting - cogeneration systems

You are here: Home / Research and Development

Innovative small helium liquefier

EuroNorm GmbH (BMWi)

Dr. Erik Neuber

+49-351-4081-5122

send mail

Liquefaction rates from 10 to 15 l/h

The goal of the R & D project is to explore new innovative ways to develop the functional model of a "helium liquefier for the small liquefaction rate". The development of such a system should cover the still non-existent area of the market.

This liquefier should contain several innovations and technical solutions:

Development of a helium liquefaction system with a liquefaction rate of 10 - 15 liters per hour of liquid helium.
Development of an innovative pre-cooling stage, which works with a mixture of helium and refrigerants as working fluid.
Detailed investigation of an innovative helium cycle within the development of the helium small liquefier with the ability to operate in different operating regimes: helium liquefaction, cooling and temperature stabilization/control.
Operation of the condenser with a liquefaction rate that can be varied over a wide range - between 75% and 100%.

Currently, the functional design of the helium small liquefier is being set up. The figure shows a 3D model of the cold box, in which all heat exchangers and cold valves are mounted. In the upper part of the cold box, two prototypes of low flow helium turboexpanders are mounted. All external components, piping and condenser control system are located on the front of the cold box.

show full article