Aktuelle Forschungsprojekte

Investigation according to DIN EN ISO 14903

Innovative Parahydrogen Generator Based on Magnets

Testzentrum PLWP at ILK Dresden

Lifetime prediction of hermetic compressor systems

All-in-one device for freeze-drying and production of biomaterial

Solar Cooling

Panel with indirect evaporative cooling via membrane

Thermostatic Expansion Valves

Characterisation of Superconductors in Hydrogen Atmosphere

Calibration leak for the water bath leak test

Certifiable connection types in cryogenics

Pulse-Tube-Refrigerator with sealed compressor

In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures

Air-water heat pumps

Non- invasive flow measurements

Ice Slurry Generation

You are here: Home / Research and Development

Innovative small helium liquefier

EuroNorm GmbH (BMWi)

Dr. Erik Neuber

+49-351-4081-5122

send mail

Liquefaction rates from 10 to 15 l/h

The goal of the R & D project is to explore new innovative ways to develop the functional model of a "helium liquefier for the small liquefaction rate". The development of such a system should cover the still non-existent area of the market.

This liquefier should contain several innovations and technical solutions:

Development of a helium liquefaction system with a liquefaction rate of 10 - 15 liters per hour of liquid helium.
Development of an innovative pre-cooling stage, which works with a mixture of helium and refrigerants as working fluid.
Detailed investigation of an innovative helium cycle within the development of the helium small liquefier with the ability to operate in different operating regimes: helium liquefaction, cooling and temperature stabilization/control.
Operation of the condenser with a liquefaction rate that can be varied over a wide range - between 75% and 100%.

Currently, the functional design of the helium small liquefier is being set up. The figure shows a 3D model of the cold box, in which all heat exchangers and cold valves are mounted. In the upper part of the cold box, two prototypes of low flow helium turboexpanders are mounted. All external components, piping and condenser control system are located on the front of the cold box.

show full article