Current research projects

Certifiable connection types in cryogenics

Modular storage system for solar cooling

Hybrid- Fluid for CO2-Sublimation Cycle

Panel with indirect evaporative cooling via membrane

Micro heat exchangers in refrigeration

Development of a Cryogenic Magnetic Air Separation Unit

CFE-Test of Cooker Hoods

Performance tests of condensing units

Ionocaloric cooling

Certification of efficient air conditioning and ventilation systems through the new "indoor air quality seal" for non-residential buildings

Calibration leak for the water bath leak test

Development of test methods and test rigs for stationary integrated refrigeration units

Helium extraction from natural gas

Investigation of material-dependent parameters

Influenced melting point of water by magnetic field

Overall System Optimization of Refrigeration Plant Systems for Energy Transition and Climate Protection

You are here: Home / Testing Equipment

Innovative small helium liquefier

EuroNorm GmbH (BMWi)

Dr. Erik Neuber

+49-351-4081-5122

send mail

Liquefaction rates from 10 to 15 l/h

The goal of the R & D project is to explore new innovative ways to develop the functional model of a "helium liquefier for the small liquefaction rate". The development of such a system should cover the still non-existent area of the market.

This liquefier should contain several innovations and technical solutions:

Development of a helium liquefaction system with a liquefaction rate of 10 - 15 liters per hour of liquid helium.
Development of an innovative pre-cooling stage, which works with a mixture of helium and refrigerants as working fluid.
Detailed investigation of an innovative helium cycle within the development of the helium small liquefier with the ability to operate in different operating regimes: helium liquefaction, cooling and temperature stabilization/control.
Operation of the condenser with a liquefaction rate that can be varied over a wide range - between 75% and 100%.

Currently, the functional design of the helium small liquefier is being set up. The figure shows a 3D model of the cold box, in which all heat exchangers and cold valves are mounted. In the upper part of the cold box, two prototypes of low flow helium turboexpanders are mounted. All external components, piping and condenser control system are located on the front of the cold box.

show full article