Current research projects

Image Investigation of materials
Image Testing of mobile leak detectors according to DIN EN 14624
Image Innovative cryogenic cooling system for the recondensation / liquefaction of technical gases up to 77 K
Image Lifetime prediction of hermetic compressor systems
Image In-Situ-Swelling Behaviour of Polymer Materials in Flammable Fluids
Image CFE-Test of Cooker Hoods
Image Industry 4.0 membrane heat and mass exchanger (i-MWÜ4.0)
Image Reduction of primary noise sources of fans
Image Electrochemical decontamination of electrically conducting surfaces „EDeKo II“
Image Development of test methods and test rigs for stationary integrated refrigeration units
Image Humidifier System for High-Purity Gases
Image All-in-one device for freeze-drying and production of biomaterial
Image 3D - Air flow sensor
Image Micro heat exchangers in refrigeration
Image Swirl-free on the move...
Image Innovative Parahydrogen Generator Based on Magnets

You are here:   /  Home


Humidifier System for High-Purity Gases

Industry and Research Instituts

Moritz Kuhn

+49-351-4081-5120

Nafion - moisture transfer

At the ILK Dresden a humidification system was developed and manufactured which is especially suitable for research facilities where very low dew point temperatures have to be adjusted and at the same time a high gas purity has to be guaranteed. The core component is a PermaPure® humidifier with Nafion® moisture exchange. The humidification system precisely controls the dew point via a bypass mixing with dry gas and also takes over the automatic filling of evacuated containers. The control system is optimised to prevent recondensation. Humidification can be controlled from any plant system via an interface. Table 1 shows the technical data of a humidification system for the humidification of synthetic air realized for the KIT in Karlsruhe. The system can be adapted for other applications, and all parameters can be adjusted to the respective requirements.

Table  1: Technical Data Humidifier System
Parameter Value
setpoint gas flow 750 litre/min
maximum relative humidity 95%
minimum dew point -60°C / -76°F
degree of gas purity 5.0
gas purity, number of particle < 5 particle/cm³

Your Request

Further Projects

Image

Software for technical building equipment

Design cooling load and energetic annual simulation (VDI 2078, VDI 6007, VDI 6020)

Image

Measurements on ceiling mounted cooling systems

Comparative performance measurement

Image

Micro fluidic expansion valve

for increasing of the efficiency of small and compact cooling units

Image

Solar Cooling

Solar Cooling with Photovoltaic

Image

Hydrogen and methane testing field at the ILK

Simultaneously pressures up to 1,000 bar, temperatures down to –253°C