Current research projects

Image Corrosion inhibitor for ammonia absorption systems
Image Mass Spectrometer
Image Preformance measurements of heat exchangers
Image Performance tests of refrigerant compressors
Image Modular storage system for solar cooling
Image Micro fluidic expansion valve
Image Characterisation of Superconductors in Hydrogen Atmosphere
Image Practical training, diploma, master, bachelor
Image State of system and failure analyses
Image Reducing the filling quantity
Image Electrochemical decontamination of electrically conducting surfaces „EDeKo II“
Image Investigation of materials
Image In-Situ-Swelling Behaviour of Polymer Materials in Flammable Fluids
Image Testing of mobile leak detectors according to DIN EN 14624
Image Software for test rigs
Image Ice Slurry Generation

You are here:   /  Home


Innovative small helium liquefier

EuroNorm GmbH (BMWi)

Dr. Erik Neuber

+49-351-4081-5122

Liquefaction rates from 10 to 15 l/h

The goal of the R & D project is to explore new innovative ways to develop the functional model of a "helium liquefier for the small liquefaction rate". The development of such a system should cover the still non-existent area of the market.

 

This liquefier should contain several innovations and technical solutions:

  • Development of a helium liquefaction system with a liquefaction rate of 10 - 15 liters per hour of liquid helium.
  • Development of an innovative pre-cooling stage, which works with a mixture of helium and refrigerants as working fluid.
  • Detailed investigation of an innovative helium cycle within the development of the helium small liquefier with the ability to operate in different operating regimes: helium liquefaction, cooling and temperature stabilization/control.
  • Operation of the condenser with a liquefaction rate that can be varied over a wide range - between 75% and 100%.

Currently, the functional design of the helium small liquefier is being set up. The figure shows a 3D model of the cold box, in which all heat exchangers and cold valves are mounted. In the upper part of the cold box, two prototypes of low flow helium turboexpanders are mounted. All external components, piping and condenser control system are located on the front of the cold box.


Your Request

Further Projects

Image

Practical training, diploma, master, bachelor

Student training - Education at ILK

Image

Test procedures for electrical components

Insulating properties of hermetic compressors

Image

3D - Air flow sensor

Anemometer for determination of 3d-air flow