Current research projects

Software modules

Air-flow test rig for fan characteristic measurement

Measurement of insulated packaging

State of system and failure analyses

Thermal engines

Lifetime prediction of hermetic compressor systems

Thermostatic Expansion Valves

Characterisation of Superconductors in Hydrogen Atmosphere

Ionocaloric cooling

All-in-one device for freeze-drying and production of biomaterial

Combined building and system simulation

Multifunctional electronic modules for cryogenic applications

Intelligent innovative power supply for superconducting coils

Test rigs for refrigeration and heat pump technology

Refrigerants, lubricants and mixtures

Certification of efficient air conditioning and ventilation systems through the new "indoor air quality seal" for non-residential buildings

You are here: Home / Research and Development

Innovative small helium liquefier

EuroNorm GmbH (BMWi)

Dr. Erik Neuber

+49-351-4081-5122

send mail

Liquefaction rates from 10 to 15 l/h

The goal of the R & D project is to explore new innovative ways to develop the functional model of a "helium liquefier for the small liquefaction rate". The development of such a system should cover the still non-existent area of the market.

This liquefier should contain several innovations and technical solutions:

Development of a helium liquefaction system with a liquefaction rate of 10 - 15 liters per hour of liquid helium.
Development of an innovative pre-cooling stage, which works with a mixture of helium and refrigerants as working fluid.
Detailed investigation of an innovative helium cycle within the development of the helium small liquefier with the ability to operate in different operating regimes: helium liquefaction, cooling and temperature stabilization/control.
Operation of the condenser with a liquefaction rate that can be varied over a wide range - between 75% and 100%.

Currently, the functional design of the helium small liquefier is being set up. The figure shows a 3D model of the cold box, in which all heat exchangers and cold valves are mounted. In the upper part of the cold box, two prototypes of low flow helium turboexpanders are mounted. All external components, piping and condenser control system are located on the front of the cold box.

show full article