Aktuelle Forschungsprojekte

3D - Air flow sensor

Micro fluidic expansion valve

Industry 4.0 membrane heat and mass exchanger (i-MWÜ4.0)

Refrigerants, lubricants and mixtures

Reducing the filling quantity

Cryogenic liquid piston pumps for cold liquefied gases like LIN, LOX, LHe, LH2, LNG, LAr

Combined building and system simulation

In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures

Corrosion inhibitor for ammonia absorption systems

Investigation of coolants

Characterisation of Superconductors in Hydrogen Atmosphere

Helium extraction from natural gas

Software for technical building equipment

Certification of efficient air conditioning and ventilation systems through the new "indoor air quality seal" for non-residential buildings

Brine (water)-water heat pump

Cold meter

You are here: Home / Testing Equipment

Innovative Manufacturing Technologies for Cryosorption Systems

Euronorm, R&D

Sandra Tippmann

+49-351-4081-5131

send mail

Vacuum Pumps for UHV and XHV

A cryosorption system is defined as a vacuum pump that captures gas on cryogenic surfaces (gas-binding vacuum pump). Thus pressures lower than 5^-12 mbar are obtainable (realisation of UHV - ultrahigh vacuum and XHV - extremely high vacuum). Cryosorption systems rely on very good heat transfer performance. This is currently being achieved with a complex, cost-intensive and risky manufacturing process. Therefore the aim of this project is to develop a new manufacturing technology that does not have this disadvantage.

For this purpose, thermodynamically important variables, such as sorption heat and heat transfer resistance were determined mathematically. A test sample was developed and constructed based on these results.

After completion of the design the test sample will be produced.

In the further course of the R&D project a test stand will be set up on which the test sample can be measured. These measurements will be checked and validated in a CFD simulation. With the help of the CFD model, various simulations for future cryosorption systems can be carried out. For example cooling times for different activated carbon masses or the thermal performance under different conditions for the cooling medium can be determined using this method.

Finally the sample production (functional sample) of a cryosorption system made of stainless steel with a precisely defined heat transfer behaviour takes place. The functional model is measured in relation to the cooling performance and pressure loss of the cooling medium and the results obtained will be included into the creation of a process instruction for manufacturing future cryosorption systems.

show full article